Minutes (flashing)
• During nighttime, the atmospheric disturbances are usually less severe and
reception is possible in most cases. A single daily reception is adequate to
keep the accuracy deviation below 1 second.
MANUAL SETTING
The following manual settings can be done in the setting mode:
• Manual time
• Calendar
• 12/24 hour time display
• Time zone
• Time reception ON/OFF (DCF ON/OFF)
• Temperature unit °C/°F setting
Press and hold the SET key for about 3 seconds to advance to the setting mode:
MANUAL TIME SETTING
In area where reception of the DCF-77 time is not possible, the time can be manually
set. The clock will then be a normal Quartz clock. Once the DCF signal is detected, it
will change the manually set time into the received time. Please proceed the
following setting steps at the first time before using the Temperature Station.
1. The hour digit in the time section starts flashing. Use the MIN/MAX/+ key to
set the hour.
Hours (flashing)
To Next Page
Loading...
Need help?
General
