• Low battery indicator
• Table standing or wall mountable
THE OUTDOOR TEMPERATURE TRANSMITTER
• Remote transmission of outdoor temperature to
temperature station by 868MHz
• Weather-resistant casing
• Wall mounting case
• Mount in a sheltered place. Avoid direct rain and
sunshine
SETTING UP:
Note: This temperature station receives only one outdoor transmitter.
1. First, insert the batteries into the Temperature transmitter. (see “Install and
replace batteries in the Temperature transmitter“).
2. Immediately after and within 30 seconds, insert the batteries into Temperature
station (see “Install and replace batteries in the Temperature station”).
Once the batteries are in place, all segments of the LCD will light up briefly.
Following the time as 0:00 will be displayed and indoor temperature. If these
are not displayed after 60 seconds, remove the batteries and wait for at least
10 seconds before reinserting them.
3. After inserting the batteries, the Temperature station will start receiving data
from the transmitter. The outdoor temperature and the signal reception icon
should then
be displayed on the Temperature station. If this does not happen
To Next Page
Loading...
Need help?
General
