(P/N) 754.118 Rev B
02/12
•
© copyright 2006-2012 Kaba Mas LLC
Page 1 of 2
OPENING THE LOCK
1. Enter valid six (6) digit combination. (Factory set to 1-2-3-4-5-6)
2. The lock will confirm a valid combination entry with a double signal.
3. Within four (4) seconds, turn handle to the open position.
4. Pull door open.
• Invalid Combination Entry - Lock will signal three (3) times.
WRONG TRY PENALTY
• Entry of four (4) consecutive invalid combinations starts a ve (5) minute
delay period.
- LED flashes red at ten (10) second intervals.
• At the end of the delay period, two more consecutive invalid combinations will
restart an additional five (5) minute delay period.
NOTE: Entry will not respond to keystrokes during delay period.
CHANGING YOUR COMBINATION
ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN
1. Enter “zero” six times.
2. Enter your existing six (6) digit combination one time.
3. Enter your NEW six (6) digit combination two times.
4. If a mistake is made wait thirty (30) seconds and repeat steps 1 - 3.
5. Test lock operation several times before closing the door.
CAUTION: When selecting a combination do not use birthday or other predictable
data that could give correlation between the user and combination. Keep the
combination secret.
USER OPERATING INSTRUCTIONS
3710
Electronic Entry Device
FEATURES
See Manager Instructions for additional features.
USER Combination
• Open Lock
• Change Combination
WRONG TRY PENALTY
• Four (4) consecutive invalid combination initiates
five (5) minute delay period.
LOW BATTERY WARNING
• Repeated LED ashing and beeping during
opening indicates battery is low and needs
immediate replacement.
AUDIO AND VISUAL SIGNAL
• Double signal - two (2) LED ashes and two (2)
beeps - indicates entry is valid or accepted.
• Triple signal - three (3) LED ashes and three (3)
beeps - indicates invalid or not accepted.
To Next Page
Need help?
General
