EasyManuals Logo

Lab.gruppen iP Series IP 900 User Manual

Lab.gruppen iP Series IP 900
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Figure 4. XLR input connector
Figure 5. XLR balanced
ithin the Neutrik® Combojack there is a ¼”(6.3mm) phone jack, which is wired in parallel with the
IP HOT
ROUND
W
XLR.
T
RING COLD
SLEEVE SHIELD/G
igure 6. ¼” TRS plug
The input impedance is high enough (20 kohms balanced) to
t
o daisy chain amplifiers, use the screw-terminal (Phoenix
ch
=
TKNKO= råÄ~ä~åÅÉÇ=áåéìíë=
n t source, connect pins 1 and 3 in the cable’s XLR plug (ring and sleeve in a
8. This is similar to the connection for
e
Figure 8. Balanced line with unbalanced equipment
F
allow ”daisy-chaining”, or multiple parallel input connections.
The headroom of the input circuits is also high enough to accep
the maximum output level from virtually any low-level signal
source. Balanced signals are less sensitive to AC hum and radio
interference. The source impedance should be less than 1 kohms
to avoid high frequency loss in long cables.
T
connector), labeled Link, provided on each channel. It is
connected in parallel with the Neutrik® Combo jack on ea
input.
To con ect an unbalanced inpu
TRS plug). If you leave a pin disconnected, you will lose 6dB.
A better method for using unbalanced sources is shown in figure
balanced lines, but pin 3 is connected to the shield at the source end of the cable. The hum and noise
rejection for the cable is equivalent to that of a balanced line. To minimize hum in the audio signal, us
balanced inputs whenever possible.
Figure 7. Unbalanced line connection
For two-channel (stereo) operation, use both channels A and B. For tandem stereo or bridged mono
operation, use only one of the inputs. See operation modes
for more details.
i~ÄKÖêìééÉå== = = = = = ========================NN
rëÉê=j~åì~ä===ám=VMM====sÉêëáçå=MKP======OMMPJMOJOR=

Other manuals for Lab.gruppen iP Series IP 900

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lab.gruppen iP Series IP 900 and is the answer not in the manual?

Lab.gruppen iP Series IP 900 Specifications

General IconGeneral
BrandLab.gruppen
ModeliP Series IP 900
CategoryAmplifier
LanguageEnglish

Related product manuals