Product Service 1-800-522-7658
7
C
C
h
h
a
a
p
p
t
t
e
e
r
r
3
3
:
:
G
G
e
e
t
t
t
t
i
i
n
n
g
g
S
S
t
t
a
a
r
r
t
t
e
e
d
d
Now that the site for your Paramount Ductless Enclosure is properly
prepared, you are ready to unpack, inspect, install, and validate your system.
Read this chapter to learn how to:
• Unpack and move the enclosure.
• Set up the enclosure with the proper supporting structure and work
surface.
• Install carbon filters and/or HEPA filters.
• Connect the electrical supply.
• Set Filter Life and Filter Check Timers.
• Reset or change the face velocity, if necessary.
• Validate the enclosure.
• Seal the enclosure to the work surface.
• If applicable, connect to an exhaust system.
Depending upon which model you are installing, you may need common
mechanical and electrical installation tools in addition to 5/16", 3/8", 7/16",
and 1/2" wrenches, ratchets, sockets, a nut driver set, a flat-blade screwdriver,
a Phillips screwdriver, and a carpenter level to complete the instructions in
the chapter.
Note: Each enclosure model weighs between 125 to 350 lbs. (55 to 152 kg).
The shipping container allows for lifting with a mechanical lift truck or
floor jack. If you must lift the enclosure manually, follow safe-lifting
guidelines. Do not lift by the front air foil.
To Next Page
Loading...
Need help?
General
