HOW TO CHANGE THE SERVICE PASSWORD
?Select "SERVICE PASSWORD"
?Press OK (F1) button.
?It is required to repeat the new password, so type the previous combination again.
?If the password typed is correct, “PASSWORD OK” is shown on display for one
second, thus reverting to the PASSWORD MANAGEMENT section; through the
EXIT button the general programming menu is restored.
?On the contrary, if the password typed does not match the previous one,
PASSWORD ERROR is displayed, thus reverting to PASSWORD MANAGEMENT
section. The procedure needs to be carried out again.
?Type the primary password
?Type the new service password, selecting a combination of 5 characters from the
letters A-B-C-D.
?It is required to repeat the new password, so type the previous combination again.
?If the password typed is correct, “PASSWORD OK” is shown on display for one
second, thus reverting to PASSWORD MANAGEMENT section.
Pressing the EXIT button the general programming menu is available again.
If the password typed does not match the previous one, PASSWORD ERROR is displayed, thus reverting to PASSWORD MANAGEMENT
section. The procedure needs to be carried out again.
11
To Next Page
Loading...
Need help?
General
