SX-01635-000, Rev. 5 3
Unpacking and Inspection
The SC-5500 Integrating Sphere System Control was thoroughly inspected and calibrated before
shipping and should be ready to operate after completing the set-up instructions. All Labsphere
instrumentation is packaged and shipped in reinforced shipping containers. Carefully check the
components after unpacking for any damage that may have occurred during shipping. If there is
any such damage, file a claim immediately with the freight carrier and contact the Labsphere
Customer Service Department at
(603) 927-4266.
The following standard items should accompany your SC-5500 shipment:
• SC-5500 instrument with instruction manual
• Power cord
• Rack mounting hardware (for rack mount option only)
• Foot pads (table mount option only)
• Calibration documentation
The following items either are provided with peripheral components or must be provided by the
customer:
• Computer control cable (9-pin connector)
• Component control cable
• Detectors and detector cabling
• Software
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General