Lagler HUMMEL - Default Chapter; Table of Contents

HUMMEL
®
01.01.2019
English / Englisch
CONTENTS
1 Introduction .....................................................................................................................................................................5
1.1 Features of the machine ................................................................................................................................................5
1.2 Description of the machine ...........................................................................................................................................5
1.3 Intended use of the machine .........................................................................................................................................5
1.4 Safety devices.................................................................................................................................................................6
1.5 Machine configuration ...................................................................................................................................................6
1.5.1 Basic equipment ...........................................................................................................................................................6
1.5.2 Optional equipment ......................................................................................................................................................7
1.5.3 Wearing parts and safety-related parts ....................................................................................................................7
2 Hazard warnings and safety instructions ...................................................................................................................8
2.1 Hazard warnings .............................................................................................................................................................8
2.2 General safety instructions .........................................................................................................................................12
3 Technical data ..............................................................................................................................................................14
3.1 Data on type plate ........................................................................................................................................................14
3.1.1 Machine type plate ....................................................................................................................................................14
3.1.2 Motor type plate .........................................................................................................................................................15
3.2 Machine data ................................................................................................................................................................16
4 Commissioning .............................................................................................................................................................18
4.1 Preparing the machine for operation .........................................................................................................................18
4.2 Connecting the power cable .......................................................................................................................................21
4.3 Switching on the machine ...........................................................................................................................................22
4.3.1 Machines with single-phase AC motor (mains voltage 230 V and 220 V) ............................................................22
4.3.2 Machines with three-phase AC motor (mains voltage 400 V) ...............................................................................22
4.3.3 General ........................................................................................................................................................................23
4.4 Switching off the machine ...........................................................................................................................................24
5 Working with the HUMMEL
®
.....................................................................................................................................25
5.1 Application tips .............................................................................................................................................................25
5.2 Regulating the sanding drum pressure ......................................................................................................................26
5.3 Changing the sanding belt ...........................................................................................................................................26
5.4 Emptying the dust bag ..................................................................................................................................................29
6 Transport and storage ..................................................................................................................................................31
6.1 Dismantling the machine before transportation .......................................................................................................32
6.2 Assembly after transportation ....................................................................................................................................35
6.3 Storage ..........................................................................................................................................................................36
2