HUMMEL
®
01.01.2019
English / Englisch
RISK OF DEATH and RISK OF PROPERTY DAMAGE from unsecured
load:
• When transported in a car or the like, the machines and all
parts must be secured against sliding!
RISK OF EXPLOSION due to sparks while sanding or a high dust
concentration in the air:
• Do not use the machine near
- sources of fires,
- flammable liquids or gases,
- potentially explosive areas!
• Do not smoke in a dusty environment, e.g. while sanding,
emptying the dust bag or cleaning the machine!
RISK OF FIRE from sparks while sanding or from spontaneous
combustion:
• Prior to sanding a nailed or screwed floor all nails or screws
must be countersunk deeply enough so that they cannot be
sanded:
- Countersink the nails for example with a hammer and a
punch!
- Tighten the screws!
• There is a high risk of fire when sanding woods with a large
amount of resin, oiled or waxed floors or metal! Therefore,
the machine must always be cleaned carefully directly
after sanding! Be certain to note the warning notices of the
manufacturers of paint, oil and wax!
• Cloths, pads, et cetera which have been immersed in oil or
wax can spontaneously combust! Be certain to note the
warning notices of the manufacturers of paint, oil and wax!
• The dust bag must always be removed from the machine
directly after sanding and emptied into a non-combustible
container outdoors! Cover this container with a non-
combustible cover and be certain to store it and the dust bag
outdoors in non-combustible environment ( Section 5.4,
Emptying the dust bag)!
• Always transport and store used dust bags in closed and
non-combustible containers!
• Always transport and store the machine without dust bag!
HAZARD WARNINGS AND SAFETY INSTRUCTIONS
2
WARNING!
9
To Next Page
