Step Thirty Nine: While holding the rotation shaft above the hole, insert the
bearing onto the rotation shaft and pushing it down to the canister cover plate.
This will fix the rotation shaft in place and you will not need to keep holding it up.
Secure the bearing using (4) 1/4”*3/4” hex bolts and (4) 1/4”*OD19*2t flat
washers.
Step Forty: Secure and tighten the (1) 5/16”*3/4” and (1) 5/16”*OD23*2t flat
washer on the rotation shaft base.
To Next Page
Loading...
