LAMAX TECH Shield - Remote Control Operations; Remote Control Layout; Arm, Disarm, and Modes; Emergency and Pairing

8
Security System Status via SMS
Send the code “00” to the control panel SIM card number to request the status information of the
security system.
Example:
System armed
- Entry and exit delay time: 0sec
- Single zone delay time: 30sec
- Siren volume: 2
- Siren ringing time: 5min
- Disarm password: 1234
Storing Emergency Numbers
Emergency numbers are the numbers that the system calls when the alarm is triggered or the system
has been disarmed. To see a list of emergency phone numbers, send the code “5” to the control panel
SIM card number.
Copy the received SMS text message and paste it into a new message. Then ll in the phone numbers
that you want called in the event of an emergency. We recommend entering the full telephone number
including the international dialling code. The text message can contain multiple phone numbers and
should be sent back to the control panel SIM card number.
Example:
Information about emergency telephone numbers may look like this:
TEL:
1. 0044123456789
2. 0044123456789
3. 0044123456789
4. 0044123456789
5. 0044123456789
After submitting the new emergency numbers, the control panel conrms receipt and changes the
settings.
IMPORTANT: Changes to the system can only be made by stored telephone numbers.
Storing Emergency SMS Numbers
Emergency SMS numbers are the numbers that the system sends an SMS to when the alarm is trig-
gered or the system is disarmed. To see a list of emergency SMS numbers, send the code “6” to the
control panel SIM.
Copy the received SMS text message and paste it into a new message. Then ll in the numbers you
want added. We recommend entering the full phone number including the international dialling code.
A text message can contain multiple phone numbers and should be sent to the control panel SIM card
number.
Saving SMS Numbers for RFID Tags
This number is used in the event that the alarm is disarmed using a RFID tag. To nd the number, send
the code “7” to the control panel SIM card number.
Copy the received SMS text message and paste it into a new message. Then ll in the number that
you want called when a RFID tag is used. We recommend entering the full phone number, including
the international dialling code. Then send the message to the control panel SIM card phone number.
Storing the Speed Dial Number
This number is used for speed dialling. Speed dialling is done by pressing the “CALL” button on the
control panel. To nd the number, send the code “8” to the control panel SIM card number.
Copy the received SMS text message and paste it into a new message. Then ll in the your chosen
speed dial number. We recommend entering the full phone number, including the international dia-
lling code. Then send the SMS message to the control panel SIM card phone number.