LAMAX TECH Shield - System Maintenance; Deleting System Accessories; Restoring Factory Settings; Other SMS Notifications

10
Deleting Sensors, RFID Tags and Remote Controls from the System
All accessories (sensors, RFID tags and remote controls) can be deleted from the system by pressing the
tamper switch 3 times in 3 seconds. The control panel emits two beeps when the accessory is cleared.
Deleting Sensors from the System
The numeric code for deleting sensors from the system is “21”. By sending the code to the control panel
SIM phone number the sensors are deleted from the system. Upon activation, the control panel sends
a conrmation SMS.
Deleting RFID Tags from the System
The numeric code for deleting RFID tags from the system is “22”. By sending the code to the control
panel SIM phone number the RFID tags are deleted from the system. Upon activation, the control
panel sends a conrmation SMS.
Deleting Remote Controls from the System
The numeric code for deleting remote controls from the system is “21”. By sending the code to the
control panel SIM phone number the remote controls are deleted from the system. Upon activation,
the control panel sends a conrmation SMS.
Restoring the System Factory Settings
The numeric code to restore factory settings of the system is “0000”. By sending this code to the control
panel SIM card phone number, the system is reset to its original settings. Upon activation, the control
panel sends a conrmation SMS.
Other SMS Notications
These notications are sent to the rst stored telephone number for SMS alerts. The alerts warn of:
- Low battery in the control panel or sensors
- Break in the power supply to the control panel
- If the tamper switch on the control panel or sensors has been activated (SMS is sent to all phone
numbers).
Arming and Disarming with a Free Phone Call
The security system can be armed by calling the control panel SIM card number. When it starts ringing,
hang up. The control panel will then call you back. The alarm is then armed.
The security system can be disarmed by calling the control panel SIM card number. Do not hang up,
wait and the system will automatically disarm. The control panel will not call you back.
IMPORTANT: When arming and disarming, voicemail must be turned o on the control panel SIM
card.