© Lampert Werktechnik GmbH 2017 11
7.4 RESHARPENING THE ELECTRODES
Please switch off the machine prior to exchanging
the electrodes. This prevents uncontrolled
triggering of the welding process.
If possible, the electrodes should be sharpened with a
diamond disk with fine or medium grain.
The recommended angle of grinding is approx. 15°.
7.5 ADDITIONAL INFORMATION AVAILABLE ONLINE:
Yo
u will find a variety of practical tips on our website
www.lampert.info clicking on “Workshop News”, where
you can also subscribe to our newsletter. Furthermore in
our “Showroom” you can have a look at various videos
and photos of different applications.
8.1 CARE OF WELDING DEVICE
Your „M280“ requires a minimum of maintenance under
normal working conditions. However, it is essential that a
fe
w points are observed in order to guarantee the
functionality and to keep the spot welding device fully
operational for years to come.
• Check the mains plug and cable as well as all welding
and connection cables regularly for damage.
• Check that the moving parts of the handpiece move
easily.
• If necessary, clean the electrode threaded assembly on
the handpiece, in order to ensure optimal contact with
the electrodes.
• Clean the device occasionally with a suitable cloth.
IF WORK OR REPAIRS THAT ARE NOT DESCRIBED IN THESE OPERATING INSTRUCTIONS ARE
NECESSARY THEN CONTACT YOUR DEALER.
WARNING!
IF FUSES REQUIRE EXCHANGING, THEN THEY MUST BE REPLACED WITH FUSES OF THE SAME TYPES
AND VALUES. THE GUARANTEE IS VOID IN THE EVENT OF EXCESSIVLY HIGH FUSING!
THE DEVICE MAY ONLY BE OPENED BY A QUALIFIED ELECTRICIAN!
To Next Page
Loading...
