Need help?Do you have a question about the Lamtec BurnerTronic BT300 and is the answer not in the manual?
General| Type | Burner Control Unit |
|---|---|
| Fuel | Gas, Oil |
| Flame Monitoring | UV, Ionisation |
| Safety Functions | Flame monitoring, burner control |
| Communication | Modbus, Profibus, Ethernet |
| Display | LCD |
| Power Supply | 24V DC |
| Operating Temperature | -20 to +60 °C |
Specifies the manual's validity for BT300 configurations and software versions.
Details the designed lifetime of the BT300 system in operating hours and years.
Instructions for environmentally correct disposal of the device and its components.
Explains safety symbols used in the document and general operator responsibilities.
Covers safety for mounting, security advice, installation, and flame sensor connection.
Check all safety functions during commissioning and document results.
Verify correct parameter settings in the system for approval.
Verify the fuel/air ratio control system's proper operation.
Verification steps for the burner sequencer part, including time parameters and signals.
Describes the five available BT300 models and their features.
Covers burner sequencer, fuel/air ratio control, and integrated leakage test capabilities.
Overview of the UI300 display, BACK, Cursor, and ENTER keys for navigation.
Describes the main menu paths: INFO, MANUAL, SETTINGS, and DATA PROCESSING.
Navigating the INFO path to view burner details like operating hours and starts.
Displays operating hours and burner starts for different modes (total, oil, gas).
How to display and interpret fault codes and diagnostic information.
Displaying software versions and checksums indicating parameter changes.
Displaying serial numbers and current positions of actuator channels.
Verifying the status of digital inputs and outputs for various functions.
Checking the status of digital outputs such as fan, ignition transformer, and oil/gas valves.
Allows manual control of burner operation: switching ON/OFF and presetting firing rate.
Procedure for entering or changing the access password for settings.
Configuring program sequence parameters like pre-purge and post-purge durations.
Configuration and parameters for the valve leakage test (ON/OFF, before ignition, after burner OFF).
Steps to activate or deactivate the pilot burner during gas operation.
Steps to activate or deactivate the pilot burner during oil operation.
Configuration for multi-stage burner operation, including stage switching thresholds.
Displays for no connection, termination errors, and general error mode.
Displays pending hints and faults related to CO/O2 levels, which can be reset.
Displays the fault history for O2/CO, including fault number, diagnostics, and duration.
Provides examples and calculations for determining valve leakage test times.
Step-by-step process for conducting the valve leakage test, including pressure monitoring.
Wiring proposition for gas line purge via roof in combination with BurnerTronic.
Detailed specifications for the BT300 unit, including power, inputs, outputs, housing, and display.
Specifications for the UI300 display unit, including dimensions, weight, housing, and flammability.
Technical specifications for Actuators 662R550, covering function, environmental conditions, and electrical safety.
Specifications for Actuators 662R5001 and 662R5003, including power, torque, and resolution.
To Next Page
