8
3 For Your Safety
3.2 Security Advice - Mounting
• Compliance with national safety regulations and standards is obligatory at all times.
• During the assembly and installation process, you must meet the standard requirements
of DIN VDE 0100, 0550 and DIN VDE 0722
• To mount the BT300 basic unit, use screw fittings with an M4 thread (UNC32) and a max-
imum tightening torque of 1.8 Nm for fastening all four fixing points. Keep in mind that
housings have improved mechanical stability when connected on surrounding contact sur-
faces.
Generally connect to an even mounting surface.
NOTICE
Deterioration of the 0.8 Nm servomotor through opening.
Opening the servomotor in a different position other than the cap of the electrical connection,
destroys the servomotor.
The warranty expires.
Open the servomotor at the cap of the electrical connection only.
NOTICE
Damaging the servomotors with 1.2 Nm and 9.0 Nm through opening.
Opening the servomotor destroys the servomotor.
The warranty expires.
To Next Page
Loading...
