4
1 General Information
1 General Information
1.1 Validity of these Instructions
This manual is valid for the burner control system BurnerTronic BT300 in any configuration.
The information contained in this document refer to the software versions BT300 v3.5 and
UI300 v3.8. If you use any other software version as mentioned previously some of the de-
scribed functions may not be available or not all available functions work as described in this
document.
1.2 Life Cycle
BurnerTronic BT300 burner management system has a designed lifetime
*
of 250,000 burner
start-up cycles, which, under normal operating conditions in heating mode, correspond to ap-
prox. 10 years of usage (starting from the production date given on the type plate).
This lifetime is based on the endurance tests specified in standard EN230/EN298 and the ta-
ble containing the relevant test documentation as published by the European Association of
Component Manufacturers (Afecor) (www.afecor.org).
The designed lifetime is based on use of BT300 according to the manufacturer’s basic docu-
mentation. After reaching designed lifetime in terms of number of burner start-up cycles, or the
respective time of usage, the BT300 must be replaced by authorized personnel.
1.3 Disposal Notes
The device contains electrical and electronic components and must not be disposed of as do-
mestic waste. The local and currently valid legislation absolutely must be observed.
*
The designed lifetime is not the warranty time specified in the Terms of Delivery
To Next Page
Loading...
