Lanner NCA-5710 - Page 81

Chapter 3: Software Setup
81
Feature
Options
Description
Legacy USB Support
Enabled
Disabled
Auto
Enables Legacy USB support.
Auto option disables legacy support if
no USB devices are connected;
Disabled option will keep USB devices
available only for EFI applications.
XHCI Hand-off
Enabled
Disabled
This is a workaround for OSes without
XHCI hand-off support. The XHCI
ownership change should be claimed by
XHCI driver.
USB Mass Storage
Driver Support
Enabled
Disabled
Enables or disables USB Mass Storage
Driver Support.
USB transfer time-out
1 sec
5 sec
10 sec
20 sec
The time-out value for Control, Bulk, and
Interrupt transfers
Device reset time-out
1 sec
5 sec
10 sec
20 sec
USB mass storage device Start Unit
command time-out
Device power-up delay
Auto
Manual
Maximum time the device will take
before it properly reports itself to the
Host Controller. Auto uses default value:
for a Root port, it is 100 ms, for a Hub
port the delay is taken from Hub
descriptor.