Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 129
dhcpserver (config-dhcpd) level commands
clrscrn
Clears the screen.
default end ip address
Restores end IP address of DHCP address pool to
the default value.
default lease time
Restores the lease time to default value (24 hours).
default start ip address
Restores start IP address of DHCP address pool to
the default value.
delete all static leases
Deletes all static leases.
delete static lease <instance>
Deletes an entry from the static lease table
<instance> = index of the entry being removed
end ip address <IP address>
Sets the end IP address of DHCP address pool.
exit
Returns to the previous level.
lease time <hours>
Sets the lease time. <number> = lease time in
hours.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
start ip address <IP address>
Sets the start IP address of DHCP address pool.
state disable
Disables DHCP server.
state enable
Enables DHCP server.
static leases <number>
Change to dhcpd static lease level.
write
Stores the current configuration in permanent
memory.
diagnostics (config-diagnostics) level commands
clrscrn
Clears the screen.
exit
Returns to the config level.
log
Enters the next lower level.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
disconnect (tunnel-disconnect:16) level commands
clrscrn
Clears the screen.
exit
Returns to the tunnel level.
flush serial disable
Does not flush serial data upon closing a tunneling
connection.
flush serial enable
Flushes serial data buffer when a tunneling
connection is closed.
flush stop character disable
Forwards the stop character from the Line to the
network.
flush stop character enable
Prevents the stop character from the Line from
being forwarded to the network.
modem control disable
Does not watch the modem control pin to
disconnect.
modem control enable
Watches the modem control pin and disconnects if it
is not asserted.
no stop character
Removes the stop character.