Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 157
ssh <optClientUsername> <host> <port>
Begin SSH session on network <host>:<port>. The
optClientUserName must match an SSH Client:
Users configuration entry. Use "" in
optClientUserName to prompt for host username
and password.
ssl
Enters the SSL configuration level.
tcpdump <parameters>
dump traffic on a network
telnet <host>
Begin telnet session on network <host>.
telnet <host> <port>
Begin telnet session on network <host>:<port>.
trace route <host>
Trace route to destination
trace route <host> <protocol>
Trace route to destination using TCP, ICMP, or UDP
tunnel <line>
Enters the tunnel level. <line> = number of the
tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent
memory.
xml
Enters the XML level.
eth1 link state change (config-action:eth1 link state change) level commands
clrscrn
Clears the screen.
default delay
Resets alarm processing delay to its default value.
delay <seconds>
Sets the delay in processing the alarm. Alarm
actions will not be executed if the cause is corrected
within this time.
email
Enters the next lower level.
exit
Exits to the config alarm level.
ftp put
Enters the next lower level.
http post
Enters the next lower level.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Displays statistics.
write
Stores the current configuration in permanent
memory.
eth2 link state change (config-action:eth2 link state change) level commands
clrscrn
Clears the screen.
default delay
Resets alarm processing delay to its default value.
delay <seconds>
Sets the delay in processing the alarm. Alarm
actions will not be executed if the cause is corrected
within this time.
email
Enters the next lower level.
exit
Exits to the config alarm level.
ftp put
Enters the next lower level.
http post
Enters the next lower level.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Displays statistics.
write
Stores the current configuration in permanent
memory.