5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 158
filesystem (filesystem) level commands
Show the contents of a file
Change the current directory to the specified
directory
cp <source file> <destination file>
Show contents of a file as a hex dump
Exits to the enable level.
Format the file system and lose all data
Show all files and directories in the current directory
Show all files and directories in the specified
directory
mv <source file> <destination file>
Move a file on the file system
Displays the last 20 commands entered during the
current CLI session.
Show file system statistics
Show all files and directories from current directory
tftp get <source file> <destination file> <host>
tftp get <source file> <destination file> <host>
<port>
tftp put <source file> <destination file> <host>
tftp put <source file> <destination file> <host>
<port>
ftp (config-ftp) level commands
Returns to the config level.
Displays the current configuration.
Displays the last 20 commands entered during the
current CLI session.
Displays the FTP statistics.
Stores the current configuration in permanent
memory.
ftp put (config-action-ftp_put:eth2 link state change) level commands
Enters the next lower level. Specify the instance for
the next lower level.
Sets default of simultaneous connection mode.
Exits to the next higher level.
Sets sequential mode; will stop after first connection
that goes through.