Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 159
mode simultaneous
Sets simultaneous mode; will make all possible
connections.
no reminder interval
Clears the FTP Put reminder interval. FTP Put is
sent once only.
reminder interval <minutes>
Sets the FTP Put reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
ftp put (config-action-ftp_put:eth1 link state change) level commands
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for
the next lower level.
default mode
Sets default of simultaneous connection mode.
exit
Exits to the next higher level.
mode sequential
Sets sequential mode; will stop after first connection
that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible
connections.
no reminder interval
Clears the FTP Put reminder interval. FTP Put is
sent once only.
reminder interval <minutes>
Sets the FTP Put reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
ftp put (config-action-ftp_put:eth0 link state change) level commands
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for
the next lower level.
default mode
Sets default of simultaneous connection mode.
exit
Exits to the next higher level.
mode sequential
Sets sequential mode; will stop after first connection
that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible
connections.
no reminder interval
Clears the FTP Put reminder interval. FTP Put is
sent once only.
reminder interval <minutes>
Sets the FTP Put reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
gateway (config-gateway) level commands
add forwarding rule <start port> <end port>
<protocol> <ip>
Add a forwarding rule without a name.