Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 620
exit
Exits to the next higher level.
mode sequential
Sets sequential mode; will stop after first connection
that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible
connections.
no reminder interval
Clears the HTTP Post reminder interval. HTTP Post
is sent once only.
reminder interval <minutes>
Sets the HTTP Post reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
http post (config-action-http_post:eth0 link state change) level commands
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for
the next lower level.
default mode
Sets default of simultaneous connection mode.
exit
Exits to the next higher level.
mode sequential
Sets sequential mode; will stop after first connection
that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible
connections.
no reminder interval
Clears the HTTP Post reminder interval. HTTP Post
is sent once only.
reminder interval <minutes>
Sets the HTTP Post reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
icmp (config-icmp) level commands
clrscrn
Clears the screen.
exit
Exits to the configuration level.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
state disable
Prevents ICMP packets from being sent or received.
state enable
Allows ICMP packets to be sent and received.
write
Stores the current configuration in permanent
memory.
if 1 (config-if:eth0) level commands
bootp disable
Disables BOOTP.
bootp enable
Enables BOOTP.
clrscrn
Clears the screen.
default gateway <IP address>
Sets the configurable gateway IP address to the
default value.