Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 619
no port
Disables the HTTP Server port.
no secure credentials
Clears the RSA/DSA certificate selection.
no secure port
Disables the HTTP Server SSL port.
port <number>
Sets the port number the HTTP server will use.
<number> = port number.
secure credentials <text>
Selects the RSA/DSA certificates by name for the
HTTP server.
secure port <number>
Sets the port number the HTTP server will use over
SSL. <number> = port number.
secure protocols ssl3 disable
Disables the protocol.
secure protocols ssl3 enable
Enables the protocol.
secure protocols tls1.0 disable
Disables the protocol.
secure protocols tls1.0 enable
Enables the protocol.
secure protocols tls1.1 disable
Disables the protocol.
secure protocols tls1.1 enable
Enables the protocol.
show
Displays the current configuration.
show auth
Displays the HTTP server authentication settings.
show history
Displays the last 20 commands entered during the
current CLI session.
show log
Displays the HTTP server log.
show statistics
Displays the HTTP statistics.
state disable
Disables the HTTP server.
state enable
Enables the HTTP server.
write
Stores the current configuration in permanent
memory.
http post (config-action-http_post:eth2 link state change) level commands
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for
the next lower level.
default mode
Sets default of simultaneous connection mode.
exit
Exits to the next higher level.
mode sequential
Sets sequential mode; will stop after first connection
that goes through.
mode simultaneous
Sets simultaneous mode; will make all possible
connections.
no reminder interval
Clears the HTTP Post reminder interval. HTTP Post
is sent once only.
reminder interval <minutes>
Sets the HTTP Post reminder interval.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
http post (config-action-http_post:eth1 link state change) level commands
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for
the next lower level.
default mode
Sets default of simultaneous connection mode.