Lantronix EDS-MD Series - Page 622

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 622
domain <text>
Sets the domain name. <text> = name of the
domain.
exit
Exits to the config level.
failover
Enter failover configuration level
hostname <text>
Sets the host name. <text> = name of the host.
if <instance>
Changes to the interface configuration level.
ip address <ip address/cidr>
Sets the IP address and network mask. Formats
accepted: 192.168.1.1 (default mask)
192.168.1.1/24 (CIDR) "192.168.1.1 255.255.255.0"
(explicit mask)
link
Enter link configuration level
mtu <bytes>
Sets the Maximum Transmission Unit (MTU) size.
no default gateway
Clears the default gateway.
no dhcp client id
Clears the DHCP client ID.
no domain
Clears the domain name.
no hostname
Clears the host name.
no ip address
Clears the IP address.
no primary dns
Clears the name of the primary DNS server.
no secondary dns
Clears the name of the secondary DNS server.
primary dns <IP address>
Sets the IP address of the primary DNS server.
priority <number>
Sets the priority for interface. <number> = priority
number.
secondary dns <IP address>
Sets the IP address of the secondary DNS server.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Show interface status
state disable
Disables the interface.
state enable
Enables the interface.
write
Stores the current configuration in permanent
memory.
if 3 (config-if:eth2) level commands
bootp disable
Disables BOOTP.
bootp enable
Enables BOOTP.
clrscrn
Clears the screen.
default gateway <IP address>
Sets the configurable gateway IP address to the
default value.
default mtu
Restores the default Maximum Transmission Unit
(MTU) size.
default priority
Restores the default priority for the interface.
dhcp client id <text>
Sets the DHCP client ID.
dhcp disable
Disables DHCP.
dhcp enable
Enables DHCP.
domain <text>
Sets the domain name. <text> = name of the
domain.
exit
Exits to the config level.
failover
Enter failover configuration level
hostname <text>
Sets the host name. <text> = name of the host.
if <instance>
Changes to the interface configuration level.