Lantronix EDS-MD Series - Page 623

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 623
ip address <ip address/cidr>
Sets the IP address and network mask. Formats
accepted: 192.168.1.1 (default mask)
192.168.1.1/24 (CIDR) "192.168.1.1 255.255.255.0"
(explicit mask)
link
Enter link configuration level
mtu <bytes>
Sets the Maximum Transmission Unit (MTU) size.
no default gateway
Clears the default gateway.
no dhcp client id
Clears the DHCP client ID.
no domain
Clears the domain name.
no hostname
Clears the host name.
no ip address
Clears the IP address.
no primary dns
Clears the name of the primary DNS server.
no secondary dns
Clears the name of the secondary DNS server.
primary dns <IP address>
Sets the IP address of the primary DNS server.
priority <number>
Sets the priority for interface. <number> = priority
number.
secondary dns <IP address>
Sets the IP address of the secondary DNS server.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Show interface status
state disable
Disables the interface.
state enable
Enables the interface.
write
Stores the current configuration in permanent
memory.
ip (config-ip) level commands
clrscrn
Clears the screen.
default ip time to live
Restores the default IP time to live.
default multicast time to live
Restores the default IP multicast time to live, which
is one hop.
exit
Exits to the configuration level.
ip time to live <hops>
Sets the IP time to live, known by SNMP as
"ipDefaultTTL". <hops> = number of hops that a
typical IP packet is allowed to live.
multicast time to live <hops>
Sets the IP multicast time to live. <hops> = number
of hops that a multicast IP packet is allowed to live.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
line 1 (line:1) level commands
auto show statistics
Continuously displays line statistics.
baud rate <bits per second>
Sets the line speed. <bits per second> = the speed.
Standard speeds include 1200, 2400, 4800, 9600,
19200, and so on.
clear line counters
Sets the serial counters to zero.
clrscrn
Clears the screen.