Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 662
show history
Displays the last 20 commands entered during the
current CLI session.
speed 10
Sets the speed of the Ethernet link to 10 Mbps.
speed 100
Sets the speed of the Ethernet link to 100 Mbps.
speed 1000
Sets the speed of the Ethernet link to 1000 Mbps.
speed auto
Sets the speed of the Ethernet link to auto-
negotiate.
write
Stores the current configuration in permanent
memory.
link (config-ethernet:eth0) level commands
clrscrn
Clears the screen.
default duplex
Restores the default duplex setting, which is auto.
default speed
Restores the default speed setting, which is auto-
negotiate.
duplex auto
Sets duplex mode to auto.
duplex full
Sets duplex mode to full.
duplex half
Sets duplex mode to half.
exit
Exit back to interface configuration level
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
speed 10
Sets the speed of the Ethernet link to 10 Mbps.
speed 100
Sets the speed of the Ethernet link to 100 Mbps.
speed 1000
Sets the speed of the Ethernet link to 1000 Mbps.
speed auto
Sets the speed of the Ethernet link to auto-
negotiate.
write
Stores the current configuration in permanent
memory.
log (config-diagnostics-log) level commands
clrscrn
Clears the screen.
default max length
Restores the factory default maximum Log file size.
default output
Restores the default log output, which is disable.
default verbosity level
Restores the Verbosity level to the default value
(Minimum).
exit
Exits to the next higher level.
max length <Kbytes>
Sets the maximum size in Kbytes for the Log file.
output disable
Disables log output.
output filesystem
Enables log to filesystem.
output line <number>
Enables log to serial line.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
verbosity level everything
Sets the Verbosity of system messages logs to the
Syslog Host to Everything.
verbosity level intermediate
Sets the Verbosity of system messages logs to the
Syslog Host to Intermediate .
verbosity level minimum
Sets the Verbosity of system messages logs to the
Syslog Host to Minimum.