Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 663
write
Stores the current configuration in permanent
memory.
mach10 (config-mach10) level commands
active connection connection <number>
Sets active connection to Connection <number>.
apply configuration updates always
Sets the action on configuration updates to Always,
signifying that the device will always apply
configuration updates.
apply configuration updates if unchanged
Sets the action on configuration updates to If
unchanged, signifying that the device will only apply
configuration updates if no changes have been
made locally.
apply configuration updates never
Sets the action on configuration updates to Never,
signifying no configuration updates will be applied.
apply firmware updates disable
Restores the default action on new firmware (do not
apply).
apply firmware updates enable
Automatically apply new firmware.
clrscrn
Clears the screen.
connection <instance>
Enters the next lower level. Specify the instance for
the next lower level.
content check interval <hours>
Sets the firmware and configuration check interval.
default active connection
Restores the default active connection, which is
Connection 1.
default apply configuration updates
Restores the default setting for configuration
updates (Never).
default content check interval
Restores the default firmware and configuration
check interval.
default status update interval
Restores the default status update interval.
device description <text>
Sets the Device Description.
device id <text>
Sets the Device ID.
device key <text>
Sets the Device Key.
device name <text>
Sets the Device Name.
exit
Returns to the config level.
line <number>
Change to line configuration level.
no device description
Removes the Device Description.
no device id
Removes the Device ID.
no device key
Removes the Device Key.
no device name
Removes the Device Name.
reboot after update disable
Restores the default action when new configuration
is applied (do not reboot) NOTE: The device will
always reboot after a firmware update.
reboot after update enable
Enables automatic reboot when new configuration is
applied.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show statistics
Displays the MACH10 statistics.
state disable
Disables the Mach10 client.
state enable
Enables the Mach10 client.
status update interval <minutes>
Sets the status update interval.