5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 699
Disables the port forwarding rule.
Enables the port forwarding rule.
Sets the LAN destination port for port forwarding
rule. <text> = port.
Stores the current configuration in permanent
memory.
Run iperf with command line parameters passed in
quoted string.
Ping destination continuously with 5 second timeout
Ping destination n times with 5 second timeout
ping <host> <count> <timeout>
Ping destination n times with x timeout (in seconds)
Displays the last 20 commands entered during the
current CLI session.
dump traffic on a network
Trace route to destination
trace route <host> <protocol>
Trace route to destination using TCP, ICMP, or UDP
rss (config-rss) level commands
Restores the default number of RSS feed entries.
Exits to the configuration level.
Sets the maximum number of RSS feed entries.
Disables RSS feed data persistence.
Enables RSS feed data persistence.
Displays the current configuration.
Displays the last 20 commands entered during the
current CLI session.
Display the RSS Feed status
Stores the current configuration in permanent
memory.
serial (tunnel-serial:16) level commands
Restores default DTR control, asserted while
connected.
dtr asserted while connected
Asserts DTR whenever a connect or accept mode
tunnel connection is active.
dtr continuously asserted
Asserts DTR regardless of any connections.
Asserts DTR to match remote DSR when connected
via Telnet.