Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 713
no gateway
Clears the gateway for static route network.
no interface
Clears the route interface. The WAN interface is
used if no interface is specified.
no network
Clears the IP address for static route network.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
state disable
Disables the static route.
state enable
Enables the static route.
static route <number>
Change to config gateway static route level.
write
Stores the current configuration in permanent
memory.
static route 8 (config-staticroute:8) level commands
clrscrn
Clears the screen.
default metric
Restores the metric to default value.
exit
Exits to the config-gateway level.
friendly name <text>
Set the friendly name for static route. <text> =
friendly name
gateway <text>
Sets the gateway for static route network.
interface <text>
Sets the route interface <text> = interface name
metric <number>
Sets the metric for static route. <number> = metric
network <text>
Sets the IP address and network mask for static
route network.
no friendly name
Remove the friendly name
no gateway
Clears the gateway for static route network.
no interface
Clears the route interface. The WAN interface is
used if no interface is specified.
no network
Clears the IP address for static route network.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
state disable
Disables the static route.
state enable
Enables the static route.
static route <number>
Change to config gateway static route level.
write
Stores the current configuration in permanent
memory.
syslog (config-syslog) level commands
clrscrn
Clears the screen.
default remote port
Restores the default syslog remote port.
default severity log level
No logging.
exit
Returns to the config level.
host <text>
Sets the address of the syslog recipient. <text> = IP
address or name of the host.
no host
Removes the address of the syslog recipient.
remote port <number>
Sets the syslog remote port. <number> = number of
the remote port used when making a syslog
connection.
severity log level alert
Log only Alert and more severe events.