Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 714
severity log level critical
Log only Critical and more severe events.
severity log level debug
Log all events.
severity log level emergency
Log only Emergency events.
severity log level error
Log only Error and more severe events.
severity log level information
Log only Information and more severe events.
severity log level none
No logging.
severity log level notice
Log only Notice and more severe events.
severity log level warning
Log only Warning and more severe events.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show statistics
Displays the syslog statistics.
state disable
Disables syslog logging.
state enable
Enables syslog logging.
write
Stores the current configuration in permanent
memory.
telnet (config-cli-telnet) level commands
authentication disable
No password required for Telnet users.
authentication enable
Challenges the Telnet user with a password.
clrscrn
Clears the screen.
default max sessions
Restores the default maximum allowed concurrent
incoming Telnet sessions.
default port
Restores the default local port to the Telnet server.
exit
Exits to the CLI level.
max sessions <number>
Sets the maximum allowed concurrent incoming
Telnet sessions. <number> = number of sessions.
port <number>
Sets the local port that the Telnet server uses.
<number> = local port number.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show statistics
Displays the Telnet statistics.
state disable
Disables the Telnet Server.
state enable
Enables the Telnet Server.
write
Stores the current configuration in permanent
memory.
terminal 1 (config-terminal:1) level commands
break duration <milliseconds>
Sets how long a break should last when it is being
sent to the line. <milliseconds> = number of
milliseconds.
clrscrn
Clears the screen.
default break duration
Restores the break duration to the default value
(500 ms).
default terminal type
Sets the default terminal type, "UNKNOWN".
echo disable
Disables echoing of characters received on the line
back to the line.
echo enable
Enables echoing of characters received on the line
back to the line.