Lantronix EDS1100 - Page 145

5: Commands and Levels
EDS1100/2100 Command Reference 145
show statistics
Displays the syslog statistics.
state disable
Disables syslog logging.
state enable
Enables syslog logging.
write
Stores the current configuration in permanent memory.
tcp (config-tcp) level commands
ack limit <packets>
Sets the number of packets that must be received before an ACK
is forced.
If there is a large amount of data to acknowledge, an ACK will be
forced
before this.
auto show statistics
Continuously shows TCP statistics
clear counters
Zeros TCP counters
clrscrn
Clears the screen.
default ack limit
Restores the default ack limit of 3 packets.
default max retrans
Restores the default Maximum Retransmissions.
default max retrans syn ack
Restores the default Maximum Retransmissions for SYN/ACK.
default max timeout
Restores the default Maximum Timeout between retransmissions.
default send data
Sets TCP to send data in accordance with standards.
exit
Exits to the configuration level.
max retrans <number>
Sets the Maximum Retransmisssions.
max retrans syn ack <number>
Sets the Maximum Retransmisssions for SYN/ACK.
It is lower than "Max Retrans" to thwart denial-of-service attacks.
max timeout <seconds>
Sets the Maximum Timeout between retransmisssions in seconds.
no clear counters
Unzeros TCP counters
resets disable
Does not send TCP RSTs upon connection to unused ports.
resets enable
Sends TCP RSTs upon connection to unused ports.
send data expedited
Sets TCP to send data whenever the window is sufficiently open,
for improved
real-time performance.
send data standard
Sets TCP to send data in accordance with standards.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show statistics
Shows TCP statistics
write
Stores the current configuration in permanent memory.
telnet (config-cli-telnet) level commands
clear counters
Sets the Telnet counters to zero.
clrscrn
Clears the screen.
default max sessions
Could not find VarID 315 in file http/config/varid_help.mtxt
default port
Restores the default local port to the Telnet server.
exit
Exits to the CLI level.
max sessions <number>
Could not find VarID 315 in file http/config/varid_help.mtxt
no clear counters
Restores the Telnet counters to the aggregate values.
port <number>
Sets the local port that the Telnet server uses.
<number> = local port number.