Operating Instructions – Mobility Wallbox Home / Home Pro 5
2 For your safety
2.1 Intended use
The product is intended for charging electric vehicles and hybrid
vehicles that can be charged with Mode 3 and Type 2 connector. Only
an original Lapp Mobility charging cable may be used for charging. To
charge a vehicle with Type 1 connector, a standard-compliant adapter
cable is required. Extension cables must not be used.
The product may only be operated when it is mounted in one of the
following ways:
– on a wall
– freestanding, only with original accessories for freestanding mounting
from Lapp Mobility.
For safe operation of the product, a type A residual current circuit
breaker is required in the building installation or in the product. A
product without an integrated type A residual current device may only be
operated if it is connected to a house installation with a type A residual
current circuit breaker.
For safe operation of the product, a circuit breaker is required in the
building installation (see technical data).
The product is intended for use in accordance with these operating
instructions. Any use of the product that deviates from these operating
instructions is considered improper.
Observe the country-specific requirements of IEC 61851-1.
2.2 Safety instructions
Danger to life due to electric shock
There is a risk of electric shock when working on the electrical
installation of the product.
► All work on the domestic installation and the electrical installation of
the product may only be carried out by a qualified electrician.
There is a risk of electric shock if damaged cables are used.
► Do not operate the product without a residual current circuit breaker or
a miniature circuit breaker.
► Check the charging cable for obvious damage before each use.
► Protect the product and the charging cable from direct sunlight.
► Only use the product if the charging cable is undamaged.
To Next Page