33 | P a g e
2.46 Menu Bar Functions
2.46.1 Laser On
If the tablet is connected to the laser, click Laser On and the laser will turn on.
2.46.2 Start New Line
While templating and measuring points, after you have taken 2 points (which will draw a line), click Start New Line
if you wish to start a new surface. This would be used when you have taken 2 points on one side of a cabinet base
and then you move to the front or back of the cabinet base.
If you do not hit Start New Line, a chamfer will be drawn connecting the 3rd and 4th points.
2.46.3 Laser Off
If the tablet is connected to the laser, click Laser Off and the laser will turn off.
2.46.4 Zoom
While you are editing the template, you can Zoom in and out to get into close areas that you need to be enlarged.
This can be done 2 different ways.
+ & -:
1. Click the + button and the drawing will zoom in.
2. You can click and drag the screen around to move to the area you want to.
3. Once finished, you can click the -button and you will zoom out.
2-Point Zoom:
1. Click Zoom.
2. Click 2 points on a diagonal in which you want to be the top and bottom corners.
1. The easiest way to do this is think about top right and bottom left or top left and bottom right
corners.
2.46.5 Best Fit
While you are zoomed in on a specific area while editing, you can click Best Fit and the template will be zoomed in
or out so that the entire drawing is fit within 90% of the window.
To Next Page