34 | P a g e
Templating Menu (Right Sidebar)
This menu is used while you are actually doing the templating and taking measurements.
2.47 Laser Mode
There are 4 drawing modes to use while templating, Line, Arc, Circle and Cross.
Line - This is the default mode that will be set up each time you open our software. Every 2 points measured will create
a line.
Arc - Every 3 points will create an arc.
Circle - There are 2 types of circles that can be drawn, 3-Point and 1-Point.
3-Point - This type of circle is used when there is a column or anything stationary that you have to template and has
to be precisely on. All you need to do is measure 3 points and the software will create a circle based on those 3
measurements.
1-Point - This type of circle is used when you are going to be putting a grommet in. The exact position is not
necessary, only the size of it. Input the radius of the circle and the next measured point will be the center of the
circle. Remember a radius is 1/2 of a circle so if you do a 2-inch radius, the circle will be a 4 inches in diameter.
Cross - Drawing a cross will simply put a cross on the measured point. This is especially useful for drop-ins, marking
center lines, as well as use with the Re-Position Laser (Leap) feature.
2.48 Erase
Clicking Erase will allow you to erase any line segment you have templated or drawn.
2.49 Distance
Using the Distance feature allows you to measure from any one point to any other point.
1. Click Distance.
2. Click 2 points on the template.
2.50 Auto Fillet
Using the Auto Fillet feature allows you to speed up your templating. You no longer need to click Start New Line when
you are moving to a new plane. This is because every third point taken will start a new line.
For example, you will take 2 points on the side of a cabinet base creating a line. The third point will then be taken on the
front of the cabinet base. Once the forth point is taken and you have to lines drawn, those are then automatically
filleted to each other creating a corner.
2.51 Fillet
Fillet allows you to add in special corners to templates. This includes corners that have been drawn in already as well as
corners that have been left open while templating.
There are 3 different types of fillets that you can add (Radii, Chamfers and Sharp Corners).
To Next Page