A: PAIRING WITH MOBILE PHONE (HFP)
Note: Ensure your mobile phone has Bluetooth capability. Pairing procedures may
vary between brand types and handsets. Please refer to your mobile phone manual
for further information
1)
Please keep the headset and mobile phone within 1 meter of each other whilst
pairing.
2)
Activate the headset pairing mode (hold the MFB (middle button) for 7 seconds –
the red and blue LED will blink alternately)
3)
Activate the Bluetooth function on your mobile phone so it can search (discover)
Bluetooth devices.
4)
When located, Select AO-BT404 in the Bluetooth device list on your phone.
5)
If a password or PIN is required, enter 0000, and press Yes or Confirm if required.
6)
After successfully pairing, select AO-BT404 in the Bluetooth device list and press
connect on your mobile phone.
7)
If the pairing is successful a blue LED on the headset will blink every 4 seconds.
Note: If the pairing is not successful, switch off the headset, and then restart the
procedure. Your device may also need to be reset.
Note: After pairing is successful, the paired devices will be stored in memory so there
is no need to repeat the pairing process. Some devices may only allow you to pair one
set of Bluetooth headsets at a time however you can use the AO-BT404 on multiple
devices (but not at the same time)
B: PAIRING AO-BT404 WITH IPAD /IPHONE
Note: Please keep the headset and iPhone/iPad® within a range of 1 meter of each
other whilst pairing.
1)
Activate the headset pairing mode (hold the MFB (middle button) for 7 seconds –
the red and blue LED will blink alternately)
2)
In the iPhone/iPad home screen, select settings，then general，then Bluetooth
To Next Page
Loading...
Need help?
General
