LaserPecker LP5 - Safety Information

The LP5 Basic is a Class 4 laser system. When assembled and locked with
a safety enclosure, the laser system is Class 1.
The active laser and its reflections can rapidly cause fires, burns, and
permanent vision damage. Under normal circumstances, the laser is
blocked by the protective cover or safety enclosure during operation. Before
using the machine, ensure that the protective cover or safety enclosure is
installed properly. If it cannot fully cover the object, you need to wear safety
goggles that can shield your eyes from the laser beams.
During operation, the materials being engraved or cut may release toxic
and harmful gases or fumes. Depending on the type and composition of
the engraving/cuing materials, these emissions can pose health and
environmental risks. To ensure safe use, it is recommended to use this
machine with an air purifier to eectively absorb and filter any toxic or
harmful gases and fumes generated.
DO NOT use this laser in dewy, dusty, or high-EMI conditions where the
active laser might easily be deflected or reflected.
2
Laser Safety
3
Electrical Safety
Only use the machine with stable and compatible power sources. This
machine requires a 24V/7.5A power adapter. Failure to use the compatible
power adapter can result in machine malfunction.
Do not allow any electronic component to become wet and always
fully disconnect the machine from power before undertaking cleaning,
adjustment, maintenance, or repair.
·
·
Safety Information
02
The warning and instruction signs are labeled where physical injuries or
damage to the machine may be caused before and/or during operation. If a
sign is damaged or lost, replace it immediately. You can use the following
template to print the sign you need.
Warning Labels
·
·
·
·