espresso coffee machines
LSI 022 - Rev. 00 - Ed. 12/2015
13
INSTALLATION OF THE WATER SOFTENER IS RECCOMENDED TO PRoLONG THE LIFE OF THE MACHINE.
Install the water softener according to the instructions and norms supplied by the manufacturer.
The water softener must be positioned where it is easily accessible so as to carry out the regeneration cycle when
necessary and should be positioned near to the water drainage u-pipe.
Do not place the drainage hose in basins or buckets underneath the counter to avoid the possibility of creating receptacles
of dirt with the consequent proliferation of bacteria.
If a water softener is not a part of the water system, it is necessary to apply a filter to the inlet hose of the motor pump to
avoid the entry of impurities that could damage the motor pump or the machine.
Danger!
Danger!
Danger!
The motor pump must be installed at a distance to avoid drips or spurts of water and also to avoid salt from dropping onto
the motor pump when filling the water softener with salt.
Before connecting the hose coming from the motor pump or from the water-softener, in case of appliances with built-in
pumps, place it in a bucket and turn on the water tap (1 - Fig. 6) for a couple of minutes in order to eliminate possible
residues from the new hoses and in any case, until the water flows clear.
Attention!
4.3 DRAINAGE SYSTEM
Assemble the push-fit drainage hose in the appropriate rubber holder of the collection basin of the machine and place the
other end of the hose directly into the drainage u-pipe of the prearranged drainage system.
Check that the hose is not blocked or crushed along its length and it also has a sufficient incline to be able to drain without
difficulty.
To Next Page
Loading...
