Programming Cables
User Guide
© 2009-2019 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal.
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
10 FPGA-UG-02042-26.2
Table 6.1. Pin and Cable Reference (Continued)
Programming cable pin type
Target Board Recommendation
Connect the programming cable wires (above) to the corresponding device or header pins (below).
Optional connections to device
PROGRAMN, INITN and/or DONE signals
iCE40™/iCE40LM/iCE40 Ultra™/
iCE40 UltraLite™
Optional connections to device PROGRAMN, INITN
and/or DONE signals
1 x 10 conn (various cables)
1 x 8 conn (see Figure 3.4)
2 x 5 conn (see Figure 3.5)
To Next Page
Loading...
Need help?
General