Proline Low-temperature Thermostats
10 Brief operating instructions YACE0072 / 21.08.07
2.1 Menu structure: Master
To reset the unit to the factory default state which enables basic operation with internal control, there is
the default function in the menu
LMDls Æ O@p@ Æ cDE Ì 7.6.4.
Bath temperature
1%21
°C
Pump power.1-8/Standby.0
Os 7
°C
Setpoint
RDr
°C
Control Intern / Extern
Bml 0
°C
Further settings
LMDkt
°C
Configure modules
LMnet
°C
End
Dlc
°C
⇒ Section 7.6.2
⇒ Section 7.6.3
Display flashes. Set setpoint
with or . Display
is accepted afer 4 sec. or
proceed immediately
with the key:
Control parameters,
setpoint resolution,
setpoint-source input,
calibration, etc.
Protection system,
Command, cooling system,
analog and RS232 digital
module, etc.
External temperature
1%/1
°C
EXT
Display flashes. Set value
with or . Display
is accepted afer 4 sec. or
proceed immediately
with the ke
:
⇒ Section 7.7.3
⇒ Section 7.7.4
⇒ Section 7.7.1
To Next Page
Loading...