To Next PageTo Next Page
Need help?Do you have a question about the Lauda RP 3530 and is the answer not in the manual?
General| Brand | Lauda |
|---|---|
| Model | RP 3530 |
| Category | Thermostat |
| Language | English |
Covers transport, damage, operation by qualified personnel, and heat carrier safety.
Details hazards, user responsibility, standards, and medical use limitations.
Covers connection, hot parts, hoses, mains cable, thermal expansion, vapors, and fault conditions.
Covers display types, probes, A/D converter, safety system, and SelfCheck Assistant.
Provides instructions for unit placement, space requirements, and connections.
Details types of heat carrier liquids, their properties, and order numbers.
Covers rating plate comparison, PE connection, and fuse switch.
Describes power switch operation, LED indicators, and self-test sequence.
Describes procedures for powering down and entering standby mode.
Describes the procedure for locking the Master keyboard to prevent accidental changes.
Explains how to lock the Command Console keyboard.
Details the main level menu and indicators for submenus.
Covers current consumption, resolution, temp limits, works settings, and device type.
Details setting Xp, Tn, Tv, Td, and Auto/Manual modes for internal control.
Details setting Kpe, Tne, Tve, Tde, Xpf, and Auto/Manual modes for external control.
Covers alarm/warning volume, high-level warning, works settings, and safety values.
Details system configuration, showing values, and service level settings.
Covers low-level warning, flushing, acclimation, test valve, and fan mode.
Explains how to set the desired bath temperature using the Master control.
Details methods for entering the setpoint using the Command Console.
Instructions for connecting a Pt100 probe and displaying external temperature.
Describes how to adjust pump speed and activate standby mode.
How to choose internal, external probe, analog, or serial control source.
Defines operational temperature boundaries and sets warnings.
Procedure for adjusting the offset of the internal temperature probe.
Procedure for adjusting the offset of the external temperature probe.
Explains program creation, segments, ramp, step, hold, and provides an example.
Covers entering, modifying, inserting, and deleting program segments.
Details Xp, Tn, Tv, Td, and Auto/Manual settings for internal control.
Explains the function and checking of the overtemperature protection system.
Describes how to set the cut-off point and handle overtemperature alarms.
Details low liquid level alarms and safety system testing.
Sets reactions for high liquid levels: no warning, warning, or alarm.
Describes high-level signals and automatic shutdown of heater/pump.
Handles alarms for pump motor overload or blockage.
Handles alarms for pump running without liquid.
Provides instructions for cleaning the unit.
General servicing advice, fuse replacement, and condenser cleaning.
Contact information and procedures for ordering spare parts.
Covers operating temp, ambient temp, humidity, resolution, and accuracy.
Details physical dimensions, weight, and power ratings.
