This is for the convenience of the maintenance personnel to quickly know the whole state of
the starting system according to the data.
If the engine starting can`t be detected, there may be no output of charging voltage, you
need to check the generator.
3.3 Charging Test
When enter the charging test, tester will prompt "Loaded testing"
Note: Do not shut down the engine during the test. All electrical appliance and
device are in OFF state. Turn on/off any electrical appliance in the vehicle during the
test will affect the accuracy of the test result.
Operate accordingly to increase the engine rotating speed to 2500turns, and keep for 5
seconds.
Tester starts the charging volt test after increase rev detected.
To Next Page
Loading...
Need help?
General
