Chapter 3 Operation
Connect the red test clamp with battery anode and the black one with cathode, the tester
will power on automatically. Voltage battery below 7.0VDC can’t be tested properly, then
press OK key to continue.
According to the tester, you can press UP/DOWN key to choose:
① Battery Test
② Cranking Test
③ Charging Test
④ Review Data
⑤ Print Data
⑥ Export Data
3.1 Battery Test
After entering battery test program, tester displays the tester model and time .
Select the battery test and press OK key to continue:
Battery Type: select your battery type, usually is “Regular Flooded”
Input testing standard: the standard which you can see the front of the
battery ,such as CCA、BCI、DIN. If you can’t find any info about the standard, you can
choose GB (Chinese standard). Choose GB standards would lead little tolerance.
Input rated capacity: you can see the starting current standards in front of the battery .Such
as CCA/500A.
Then press OK key to start testing. You may get the testing result as following:
To Next Page
Loading...
