LAUNCH KES-200 Ignition Waveform
D-1
Brief Introduction
KES-200 has multimeter function, with which the user
can measure the voltage, frequency and duty cycle of
automotive sensors, as well as battery voltage, RPM,
starting current and charging current.
Specifications
Item Measuring range
Voltage
DC –120~+120V
Current
-0.4~0.4A
Resistance
0.0~40.0MΩ
Frequency
1Hz~100kHz
Duty cycle
0~100%
Battery voltage
9~15V
Tachometer
500~8000rpm
Getting Started
How to Enter
Insert the engine analysis cartridge into the main unit.
Then switch on the main unit. The unit will enter the
start interface. On the start interface, press any key
(except [Reset], [Power] and [Exit]), the screen will
display the main menu.
Press [2] key on the main menu to enter the
[MULTIMETER] function. The screen will display the
menu for multimeter as shown in Fig.3-01. The user
may press a corresponding number key directly or
use [▲] [▼] keys to select a desired function, and
then press [ENTER] key to measure.
Fig.3-01
Description of available functions：
[1.VOLT METER]: Entering voltage-measuring mode
of CH1.
[2.CURRENT METER]: Entering the current test
mode of channel 2.
[3.RESISTANCE METER]: Entering the resistance
test mode of channel 1
[4.FREQUENCY METER]: Entering
frequency-measuring mode of CH1/CH2.
[5.DUTY CYCLE]: Entering duty cycle measuring
mode of CH1/CH2.
[6.BATTERY VOLT]: Entering battery voltage
measuring mode.
[7.RPM METER]: Entering RPM and its
stability-measuring mode.
Voltage Measuring
Please follow Fig.3-02 to connect the cables for
voltage measuring.
The measuring signal for multimeter can be inputted
only through CH1. When testing voltage, current,
resistance, duty cycle, frequency and battery voltage,
the connection is as shown in Fig.3-02.
2
3
1
4
8
5
6
7
Fig.3-02
1. KES-200 main unit
2. Engine analysis cartridge
3. Battery
To Next Page
Loading...
