LAUNCH KES-200 Cylinder Analysis
G-7
Fig.7-14
Note:
If the signal clamp of cylinder 1 cable is not
connected to the high-tension cable of
cylinder 1, but to the high-tension cable of
another cylinder, the cylinder disabling
order will be changed in accordance with the
firing order. For example, for a 4-cylinder
engine, the firing order is “1-3-4-2”, if the
signal clamp is connected to cylinder 3, the
displayed firing order is still “1-3-4-2”, but
the practical cylinder disabling order is
“3-4-2-1”.
After test, the result can be saved. Press [1] key,
the screen will display a menu as shown in
Fig.7-15.
Fig.7-15
Press [▼] [▲] keys to select the address, and
then press [ENTER] key to save the result. For
example, select “8. WAVEFORM 8” to store
current waveform, and press [ENTER] key, the
screen will display as shown in Fig.7-16.
Fig.7-16
Note:
♦ The saved address will be marked with
“*”.
♦ At most 8 waveforms can be saved.
When all of the 8 addresses have been
saved, if you want to save a new
waveform, the new one will replace the
old one of the first address.
♦ When you select the address marked
with “*” to store a waveform, the new
one will replace the old one after
pressing [ENTER] key.
The following operations can be done at
present:
z Press [2] key to view the stored results; or
z Press [Print] key to print the present test
result; or
z Press [ENTER] key to perform the power
balance test again; or
z Press [ESC] key to exit the automatic
power balance test.
When the engine has 4 or less cylinders,
KES-200 will directly start power balance test
after selecting cylinder number and pressing
[ENTER] key. It is not necessary to input the
firing order for engines with 4 or less cylinders.
To Next Page
Loading...
