Launch KES-200 - Page 47

LAUNCH KES-200 Cylinder Analysis
G-8
View the Tested Waveform
On the second-level menu shown in Fig.6-01-4,
press [2] key to select [2. View], the screen will
display a list of stored waveforms, as shown in
Fig.7-17.
Fig.7-17
Press [▲] [▼] keys to select a waveform, and
then press [ENTER] key, the screen will display
the content of the record as shown in Fig.7-18.
Fig.7-18
The following operations can be done:
z Press [Print] key to print the waveform; or
z Press [ESC] key to exit; or
z Press [1] key to view other waveforms.
Note:
♦ There are at most 8 waveforms stored.
♦ The saved address is marked with “*”.
Operation Procedure of Manual Power Balance Test
On the first-level function menu, press [2] key to
enter the second-level function menu, as shown
in Fig.7-04.
On the second-level function menu, following
operations are available:
z [ESC]: to exit;
z [HELP]: to view the help information, as
shown in Fig.7-05.
After entering the help interface, press [▲] or
[▼] key to select the item you want to see and
press [ENTER] key.
Enter the Power Balance Test
On the second-level function menu, select
[1.TEST]. The screen will display the interface
for selecting the number of cylinders, as shown
in Fig.7-06.
Press [►] [◄] keys to select the number of
cylinders of the tested vehicle, or enter the
number manually.
If the vehicle has an engine with more than five
cylinders, e.g. 6 cylinders, the number of
cylinders should be inputted. The screen will
display the interface as shown in Fig.7-07 after
inputting number and pressing [ENTER] key.
Manually input the firing order and press
[ENTER] key. The screen will display as shown
in Fig.7-08.
Note:
Make sure to input the correct firing order. If
a wrong firing order is inputted, the screen