LAUNCH KES-200 Cylinder Analysis
G-10
After test, the result can be saved. Press
[1.SAVE] key. The screen will display a menu as
shown in Fig.7-22.
Fig.7-22
Press [▼] [▲] keys to select the address, and
then press [ENTER] key to save the result. For
example, select “8. WAVEFORM 8” to store
current waveform, and press [ENTER] key, the
screen as shown in Fig.7-23 will be displayed.
Fig.7-23
Note:
♦ The saved address will be marked with
“*”.
♦ At most 8 waveforms can be saved.
When all of the 8 addresses have been
saved, if you want to save a new
waveform, the new one will replace the
old one of the first address.
♦ When you select the address marked
with “*” to store a waveform, the new
one will replace the old one after
pressing [ENTER] key.
The following operations can be done at
present:
z Press [2] key to view the stored results; or
z Press [PRINT] key to print the present test
result; or
z Press [ENTER] key to perform a new round
of power balance test; or
z Press [ESC] key to exit the manual power
balance test.
When the number of cylinders is not over 4,
KES-200 will automatically start power balance
test after the number of cylinders is selected
and [ENTER] key is pressed. It is not necessary
to input the firing order for the engine with 4 or
less cylinders since their firing order is fixed.
View the Tested Waveform
On the second-level menu shown in Fig.7-04,
press [2] key to select [2. View], the screen will
display a list of stored waveforms, as shown in
Fig.7-17. Then you can press [▲] or [▼] key to
select a waveform or press [ESC] to exit. After
selecting a waveform and pressing [ENTER]
key, the screen will display the content of the
waveform as shown in Fig.7-24.
Fig.7-24
The following operations can be done:
z Press [PRINT] key to print the waveform;
z Press [ESC] key to exit; or
To Next Page
Loading...
