LAUNCH KES-200 PC Link
H-10
[ZOOM IN/OUT] button is selected. The time
scale will change circularly following the order
of 10ms-5ms-2ms-1ms and the voltage scale of
1-2-5-10.
GRIDDING: Display or not display grid.
Print
This function may be used to print the
waveforms and data.
Exit
Exit the function and return to the main menu
Ignition Function
The ignition-recording function is to load the
ignition waveform records already saved in the
cartridge memory. Select [7.PC LINK] function
on the Ignition Function to run KES-200 PC
LINK program directly.
Click the [Ignition] button on the main interface,
the system will enter the Oscilloscope Function
as shown in the Fig.8-05.
Fig.8-05
System Setup
This function is mainly used to set up the
communication port. See Fig.8-06.
Fig.8-06
Open
This function is the same as that of the
oscilloscope; the only difference between them
is the extended name. The extended name of
ignition waveform is [.IGN].
Save
This function is the same as that of
oscilloscope.
PC Link
This function can load the ignition waveform
record. KES-200 will send all saved waveform
records to the computer. After finished, it will
display the first waveform record. See Fig.8-07
for example.
Fig.8-07
At this time, the user can select the waveforms
to be recorded. The number of waveforms to be
recorded should not be more than 8. For better
observation of the waveforms, the
corresponding function may be selected:
Mode
Change display mode—Single cylinder
To Next Page
Loading...
