LAUNCH KES-200 PC Link
H-9
Oscilloscope Function
The Oscilloscope Function is to load the
waveform records already saved in KES-200
memory. The waveform records can be saved
in the computer by using this function. It is
helpful to observing waveforms later on.
Select [6.PC LINK] in oscilloscope function to
run the PC link program directly.
To enter Oscilloscope Function, click [Scope]
button on the main interface, the screen will
display as in the Fig.8-02.
Fig.8-02
System Setup
This function is mainly used to set up the
communication port (COM1 or COM2). See
Fig.8-03.
Fig.8-03
Open
This function allows opening waveform files
already saved in the computer. The extended
name of OSCILLOSCOPE waveform files is
[.OSC]. While using this function, select a file
that the user wants to open on the pull-down
menu, and then click the [OPEN] button,
Save
This function allows saving the current
waveforms to the computer. While using this
function, click the [SAVE] icon; select the file to
be opened in the selection dialog box.
PC Link
This function can load the ignition waveform
records. KES-200 will send all saved waveform
records to the computer. After finishing, it will
display the first waveform record. See Fig.8-04
for example.
Fig.8-04
Then, the user can select the waveforms to be
recorded. The number of waveforms to be
recorded should not be more than eight. For
better observation of waveforms, the
corresponding function can be selected:
Channel: Select a channel waveform to be
adjusted on a pull-down menu, the current
channel is marked in red on the left side of the
waveform.
Move: Move the waveform by using [▲] [▼]
[◄] [►] keys, and adjust the location of the
waveform. Before using this function, make
sure the [MOVE] button is selected.
Zoom in/out: Zoom in or zoom out waveform
by using [▲] [▼] [◄] [►] keys, and then
adjust the time value and voltage value of each
grid. Before using this function, be sure the
To Next Page
Loading...
