EasyManua.ls Logo

Launch KES-200 - System Requirement; Software Installation; Connection; Main Interface of PC Link

Default Icon
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LAUNCH KES-200 PC Link
H-8
System Requirement
A set of KES-200 and PC are required, the
lowest software configuration is as shown in the
table below:
Item Requirement
CPU 80586 DX up
ROM 16M byte up
Display
VGA 800×600 up
Operating System Windows 95/98
Printer Common printer (e.g. HP
Laser Jet 6L)
COM. Port COM1 or COM2
Software Installation
z Insert the attached PC LINK CD into the
CD driver of PC set.
z On the setup interface (If it is not
displayed, double click the file
“KES-200.exe” on CD driver), please
click “Install Scope /Ignition Software”
and “Install Diagnostic Testing Software”
in turn by following the instructions on
the screen.
z After installation, PC will create an icon
of “PC LINK” program on the screen.
z Double click the “PC LINK” icon to enter
the main menu for PC link.
Connection
z Connect the 15PIN end of PC cable to the
“PC/Printer” interface on KES-200;
connect the other end to COM1 (or COM2)
port of PC.
z Connect KES-200 to the 12V DC switch
power or let KES-200 enter the testing
mode to get power.
Main Interface of PC Link
The main interface of PC link is as shown in
Fig.8-01.
Fig.8-01
[Scope]
The Oscilloscope Function is to upload the
waveform records already saved in the memory
cartridge to PC. The waveform records can be
saved in the computer by using this function. It
is helpful to observing waveforms later on.
Select [6.PC Link] function on oscilloscope
function of KES-200 to run KES-200 PC LINK
program directly.
On the main interface, click [Scope] button, the
system will enter the Oscilloscope Function.
[Ignition]
The ignition-recording function is to upload the
ignition waveform records already saved in the
memory cartridge to PC.
Select [7.PC LINK] on the Ignition Function to
run KES-200 PC LINK program directly.
On the main interface, click [Ignition] button, the
system will enter the ignition-recording function.
[About]
On the main interface, click [About] button, the
system will display the version information of
PC link software.
[Exit]
On the main interface, click [Exit] button, the
system will exit PC Link function.

Table of Contents

Related product manuals