LAUNCH
5
Connect it to the modem via the crossover cable. It only applies to the SmartLink Super Remote
Diagnostics.
4. DC-IN power jack
It can obtain power via connecting the diagnostic cable to the vehicle’s DLC port or connecting to an
external DC power supply.
Warning: It is prohibited to connect this power jack to an external DC power supply when the SmartLink C V2.0
device is properly connected to the vehicle’s DLC port.
No responsibility can be assumed for any damage or loss caused as a result of not strictly following the warning.
5. Data I/O port
• Connect it to the tablet to perform vehicle diagnosis.
• Connect it to the PC to perform J2534 reprogramming when as a J2534 PassThru device.
1.4 Technical Parameters
1. Display tablet
Operating system: Android
Memory: 4GB
Storage: 64GB
Screen: 10.1 inch capacitive touch screen with a resolution of 1280 x 800 pixels
Camera: Rear-facing 8.0MP camera
Connectivity:
• Wi-Fi (802.11a/b/g/n/ac)
• Bluetooth
Working temperature: 0℃ ~ 50℃
Storage temperature: -20℃ ~ 70℃
2. SmartLink C V 2.0 device
Size: 200mm x 110mm x 47mm
Working voltage: DC 9~36V
Power consumption: ≤ 6W
Communication: wireless and wired
Working temperature: 0℃~ 50℃
To Next Page
Loading...
